
Graduation Blank DIY Kit
Need Extra Pieces or The Graduation Cap? Get those HERE
Sublimation
1- 62" White 100% Polyester Stole
1- 9.25" x 9.25" Graduation Hat Topper (Bass Wood)
1- Laminate Sheet for Sublimating - Single Sided
1- Graduation Cap Key Chain
1- 2023 Tassel Charm
1- 12"x18" Garden Flag **Garden Flag Pole not Included**
5- Mini Fan Flags w/ Waver Pole: Flag is approximately 8.25 x 5.5 (size may vary slightly)
1- Roll Double Sided Tape - For Mini Flags
**Mini Flags do have an insert for pole- These fuse closed when subbed. Use the Double Sided Tape to adhere to pole**
Instructions for Completing the Hat Topper
Paint the Bass Wood with 2 coats of Flat or Chalk White Paint, **do not use glossy paint** allow to dry
Place Laminate Sheet - Glossy Side UP - on top of Bass Wood - Cover with Butcher Paper
Press @ 400 Degrees with Light to Medium Pressure for 15 Seconds - Immediately place it to the side to cool WITH SOMETHING HEAVY ON TOP TO PREVENT WARPING
Place your print image side down ontop of laminated Bass Wood - Press @ 400 Degrees with Light to Medium Pressure for 60 seconds. Remove paper - Immediately place it to the side to cool WITH SOMETHING HEAVY ON TOP TO PREVENT WARPING
Remove Button from top of Graduation Cap.
Slide Tassel loop through the charm.
Apply Wood Glue to raw side of Bass Wood (the side that was not subbed) Place Bass Wood centered in top of Cap PLACE SOMETHING HEAVY ON TOP until dry. Glue button in center of cap with Glue of Choice (Wood Glue/Hot Glue/E6000 work well)
Place Tassel and Cap Button Top centered in the top of cap and glue in place.
Time and Temp
Flags/Stole/Key Chain - 400 Degrees - Medium Pressure - 60 Seconds